IPX10:4
IPX10:4
FOUR CHANNELS. 2,500 WATTS EACH.
A four-channel DSP install amplifier with the headroom to drive a building.
Put 2,500 watts on every channel and stop thinking about headroom. The IPX10:4 drives four channels of install audio with onboard DSP, so processing and amplification live in one rack space instead of two. Direct Drive runs 70V/100V lines straight off the amp — no bulky transformer, no insertion loss. Spec it, rack it, and trust the spec sheet to hold.
Key features
Headroom on every output
four channels at 2,500W each.
Amp and DSP in one box
onboard processing cuts the outboard rack.
Drive lines without a transformer
Direct Drive mode powers 70V/100V directly.
Built for the rack
Euroblock I/O, GPIO, and 32A mains for permanent installs.
Runs with the system
integrates into the Dynacord SONICUE control ecosystem.
Put it on the network
OMNEO/Dante audio, synchronized at 48/96 kHz, with FIR drive processing.
Short introduction
IPX Series Amplifiers
Complete the System
Where this unit fits, and what it pairs with.
Specifications
Overview & Features
- Configuration
4-channel
Acoustic Performance
- Frequency Response
20 Hz to 20 kHz (±0.5 dB)
- THD+N
< 0.05 %
- Crosstalk between channels (dBA)
< -80 dB
Power & Amplification
- Total Output Power*
10.000 W
- Bridged Output Power 4 Ω
5200 W
